How To Jump A Hyundai Elantra

Habitation
Top
Sitemap
Contacts

Hyundai Elantra Owners Transmission

Jump starting

Hyundai Elantra: Jump starting. Connect cables in numerical order and disconnect in reverse order.

Connect cables in numerical order and disconnect in opposite society.

Jump starting tin be dangerous if done incorrectly. Therefore, to avert damage to yourself or damage to your vehicle or bombardment, follow the jump starting procedures. If in doubt, we strongly recommend that you have a competent technician or towing service jump start your vehicle.

Caution

Use just a 12-volt jumper system. You tin can damage a 12-volt starting motor, ignition organisation, and other electrical parts beyond repair past use of a 24-volt ability supply (either ii 12-volt batteries in series or a 24-volt motor generator set).

WARNING - Battery

Never attempt to check the electrolyte level of the battery as this may cause the battery to rupture or explode causing serious injury.

Warning - Battery

Go along all flames or sparks abroad from the battery. The battery produces hydrogen gas which may explode if exposed to flame or sparks. If these instructions are not followed exactly, serious personal injury and damage to the vehicle may occur! If yous are non sure how to follow this procedure, seek qualified aid. Automobile batteries contain sulfuric acrid. This is poisonous and highly corrosive. When jump starting, wear protective glasses and be careful non to get acrid on yourself, your vesture or on the auto.
Practice not attempt to jump start the vehicle if the discharged battery is frozen or if the electrolyte level is low; the battery may rupture or explode.

Jump starting process

1. Make sure the booster battery is 12- volt and that its negative terminal is grounded.

2. If the booster battery is in another vehicle, do not allow the vehicles to affect.

3. Turn off all unnecessary electrical loads.

four. Connect the jumper cables in the exact sequence shown in the analogy. Start connect one end of a jumper cable to the positive terminal of the discharged battery (1), and then connect the other finish to the positive concluding on the booster battery (2). Proceed to connect 1 end of the other jumper cable to the negative terminal of the booster battery (three), so the other end to a solid, stationary, metallic point (for instance, the engine lifting bracket) abroad from the battery (4). Practise not connect it to or well-nigh whatever office that moves when the engine is cranked.

Practise non let the jumper cables to contact anything except the correct bombardment terminals or the correct basis. Do not lean over the battery when making connections.

Circumspection - Battery cables

Do non connect the jumper cable from the negative final of the booster battery to the negative final of the discharged battery. This can cause the discharged battery to overheat and crevice, releasing battery acid.

5. Start the engine of the vehicle with the booster bombardment and allow it run at 2,000 rpm, so kickoff the engine of the vehicle with the discharged battery.

If the cause of your bombardment discharging is non credible, you should have your vehicle checked by an authorized HYUNDAI dealer.